Product Description
Removable PVC Bag for Fishers/inflatable boats equip.- Red
Produced with the same Valmex PVC Boat 7318 as our Bengartastic inflatable boats, the PVC bag match perfectly to your inflatable boat. Who likes to have baits lying around the boat? We don't!
This product is composed with a PVC velcro strap to be pasted on the boat and a bag that you can attach to the velcro strap itself. To create an efficient on board fishing station or just a comfy place where to stove your stuff and take back home.
The bag is waterproof, extremely resilient and comes with a handle on upper part for an easy daily transport. Ideal equipment for fisherman or just water lovers who like a tidy boat.
Instruction for Glueing
This instruction is created to explain how to attach various equipment to your boat by using our Bengar Montage Kit. The kit includes glue, thinner, duct tape and a brush.
Step 1: Mark and Mask
Hold the equipment you want to attach against the boat and mark the space you will need with a water-based felt marker. Mask this particular space afterwards with the duct tape. Be aware to mask 0,3-0,5 cm more than you actually marked. Clean the marked spaces and and erase the marks.
Step 2: Preparation and Glueing
First of all open the glue with a slotted screwdriver. If the glue is to viscous, please use the enclosed thinner to ensure a perfect consistency. The glue evaporates quickly so you will have to use the thinner a few times, as soon as you realize that the glue is to viscous again. Lay on a first layer of glue on the marked spot on your boat and on the equipment you wish to glue by using the enclosed brush. The best way to do it is by spreading it from in- to the outside so all edges are glue-brushed. Leave it then to dry for about 15 - 20 minutes. The brush should always be kept in the glue or thinner otherwise it will harden. Don't leave the glue or thinner open or uncovered. Close it even during small breaks. Afterwards spread a second layer of glue and remove the duct tape. Lave it to dry for another 5 minutes.
Step 3: Warming and Glueing
Use a hot air gun on the maximum power level to heat up the space where you want to glue on the boat and the equipment for about 30 seconds. Take care of not holding it too long on one spot, otherwise the material could get burned. Our tip: move the hot air gun constantly so it ain’t going to stay longer on one spot than it should. You can also use a hair dryer but you have to pay attention that the spaces you want to glue become warm enough. Be aware of the fact that as soon the booth parts get connected, it will be impossible to reattach it again. After the glueing of the equipment to the boat you should use a little drum or bottle to roll over the glued space to avoid air bubbles and make sure it is connected perfectly.
Step 4: Drying Period
Now you should leave the boat to dry for at least 24 hours so the glue can harden. Leave the glued space smooth and even. If you fold the boat while the drying period it could happen that the equipment hardens in an buckled position.
In scope of delivery
- 1 x PVC Bag
- 1 x Velcro Strap
Technical Data
Part Number | PV-43 |
---|---|
Barcode | 0700736969489 |
Weight | 0.24 kg |
Product Weight | 0.24 kg |
Size | Nein |
Made in | Ukraine |
Delivery time | 3-5 Days |
Manufacturer | Bengar |
Mounting | Glue |
Material | Boat Skin |
Color | Red |