D-Ring green for PVC inflatable boats
Our D-ring is a high-quality product specifically developed for nautical purposes. Consisting of a double PVC layer (Valmex Boat 7318: the same quality of our boats) and an iron steel O-ring with the best pulling performances on the market.
This practical D-ring can be pasted on the external of the inflatable boat to provide an excellent anchor and docking point, or to fix and secure any stuff/bag/equipment/case/tank on board when glued inside the craft. This D-Ring comes in several colors to provide the best design and finishing touch to any boat.
Extremely simple to glue on any PVC inflatable boat with our professional PVC 2 components glue. Since years we provide this item on any Bengar inflatable boat granting the highest satisfaction level of our customers. To accomplish any need of our customers we just introduced in our offer line a O-Ring and a V-Ring which come only in black matt.
Instruction for Glueing
This instruction is created to explain how to attach various equipment to your boat by using our Bengar Montage Kit. The kit includes glue, thinner, duct tape and a brush.
Step 1: Mark and Mask
Hold the equipment you want to attach against the boat and mark the space you will need with a water-based felt marker. Mask this particular space afterwards with the duct tape. Be aware to mask 0,3-0,5 cm more than you actually marked. Clean the marked spaces and and erase the marks.
Step 2: Preparation and Glueing
First of all open the glue with a slotted screwdriver. If the glue is to viscous, please use the enclosed thinner to ensure a perfect consistency. The glue evaporates quickly so you will have to use the thinner a few times, as soon as you realize that the glue is to viscous again. Lay on a first layer of glue on the marked spot on your boat and on the equipment you wish to glue by using the enclosed brush. The best way to do it is by spreading it from in- to the outside so all edges are glue-brushed. Leave it then to dry for about 15 - 20 minutes. The brush should always be kept in the glue or thinner otherwise it will harden. Don't leave the glue or thinner open or uncovered. Close it even during small breaks. Afterwards spread a second layer of glue and remove the duct tape. Lave it to dry for another 5 minutes.
Step 3: Warming and Glueing
Use a hot air gun on the maximum power level to heat up the space where you want to glue on the boat and the equipment for about 30 seconds. Take care of not holding it too long on one spot, otherwise the material could get burned. Our tip: move the hot air gun constantly so it ain’t going to stay longer on one spot than it should. You can also use a hair dryer but you have to pay attention that the spaces you want to glue become warm enough. Be aware of the fact that as soon the booth parts get connected, it will be impossible to reattach it again. After the glueing of the equipment to the boat you should use a little drum or bottle to roll over the glued space to avoid air bubbles and make sure it is connected perfectly.
Step 4: Drying Period
Now you should leave the boat to dry for at least 24 hours so the glue can harden. Leave the glued space smooth and even. If you fold the boat while the drying period it could happen that the equipment hardens in an buckled position.
In Scope of Delivery
- 1 x D-Ring
|Product Weight||0.1 kg|
|Delivery time||3-5 Days|