How to install a Railblaza Tracport Dash on a boat?
TracPort Dash 1500 rack with multiple holding points for boat equipment.
Never dreamed to have 5 rod holders where you have 2? The TracPort Dash is a multi-pin rack where to install all your boat equipment at once! The 1500 mm rack is equipped with 5 fully adjustable StarPorts, to hold any Railblaza accessory, and a StarPort adapter to install the Dash on any Railblaza mount. This RailBlaza rail with multiple mounts provides several installation point for all your fishing and navigation equipment at the same time. Moreover you can add to the TracPort Dash 1500 an extra StarPort TracNuts to add more brackets. We offer a male Starport-Adapter to make anything Railblaza compatible. The TracPort Dash 500 requires 2 StarPorts pre-installed to the surface or rail it will be mounted on. If these StarPorts are at 100mm(4″) distant the pre-drilled mounting holes on the TracPort Dash 500 can be used. Drilling holes in TracPort [A]: If the StarPorts on your vessel are not at 100mm (4″) centers you will need to drill new mounting holes for the adaptors. Remove endcap screws and take off the endcap [B] from one end, then loosen the screws on the front of the StarPorts and remove enough StarPorts [C] to give access to the TracPort surface, mark and centre punch new drilling points at the same centers as your StarPorts. Using a 6.5mm (1/4″) drill bit, drill through the TracPort, then countersink the holes on the inside, ready for the countersunk screw head. Fitting the adaptors [D]: The two supplied adaptors come with nuts inserted. Thread the plastic washers onto the screws before inserting bolts through the TracPort and screwing loosely into the adaptors. Place the adaptors into your StarPorts, and then tighten the screws using the phillips screwdriver. Fitting the optional Infill Extrusion [E] The TracPort infill strip is used to trim the extrusion and reduce fouling. Once your accessories have been mounted, use a sharp knife, scissors or a guillotine to cut strips of infill to length and press them firmly into the extrusion from the front, not slide in from the end.
This product requires a mount:
You can find here the latest brochure about the whole range of Railblaza products - online browse or download as PDF
In Scope of Delivery
- 1 x Aluminium Rack with 5 Starport TrucNuts
- 2 x Plastic caps
- 1 x Gasket
- 2 x Star Adaptor/Pin
|Product Weight||2.3 kg|
|Size||Länge: 1,51 Meter, Breite: 9 cm, Höhe: 5 cm|
|Made in||New Zealand|
|Delivery time||3-5 Days|
|Mounting||No assembly required|